AGW-375-4

The components required for suite master are not published. Please check your publish settings in Fusion and republish the site.

"; } else { echo "

An error occured. Please contact the site administrator

Error code: 103

"; } exit(); } require_once($nof_rootDir . "/" . $nof_scriptDir . "/" . "nof_utils.inc.php"); $nof_resources->addFile($nof_langFile); ?> AGW-375-4

Calendar
Testimonies
Linecard
Minority
Contacts
Videos

Vision
Motion
Controls
Sensors
Safety
Mechanical

Sign up for our Email Newsletter

Click here for listings for our classes and events

Grippers

Rotary Actuators

Powered Slides

Mini Power Slides

Feed Escapement

Hand Exchange

Load Limiters


	Contact information: IC Engineer: Roger Leep (616)-931-1322 roger@industrialcontrol.com Website: www.agi-automation.com Contact AGI: (203)-459-8345


	AGW-375-4 Wide Body Series Parallel Gripper

PRODUCT SPECIFICATIONS

FEATURES AND BENEFITS

Design: Parallel-Double Acting Synchronized Jaws

Stroke: 4"

Gripping Force per Jaw @ 80psi: Closing = 36 lbs.; Opening = 38 lbs.

Time: Close = 0.6 sec.; Open = 0.6 sec.

Air Consumption: 490 cubic inches/min

Pressure Range: Low = 30 psi; High = 150 psi

Temperature Range: Low = -20 F; High = 180 F

Side Play: +/- 0.001"

Repeatability from Center: +/- 0.002"

Displacement: 2.46 cubic inch

Material: High strength, hard coated aluminum alloys and steel

Weight: 3.2 lbs

Piston Diameter: .625 in. x 4

Ultra high gripping force to weight ratio due to four opposing independent pistons that direct power to the jaws
True parallel jaw motion for easy tooling.
Units are permanently lubricated for non-lube air operation, allowing for OSHA compliance.
Piston seals are quad-ring type for long service life.
Large jaw support shafts are guided through the full width of the main body.
Proximity switches are available to monitor open and closed position of the jaws.
Series AGW-375-4 is fully field repairable for cost savings and minimum down time.
Non-synchronous versions allow the gripper's jaws to comply to the part's centerline versus the gripper's centerline.




	Calvary CRC Golf



		Partner Login


			2008 Training Schedule



			Click here for listings for our classes and events



	Industrial Control Service Inc. --- 9267 Riley St. Zeeland, MI 49464 --- phone: 800-878-6722 --- fax: 616-748-0060

AGW-375-4 Wide Body Series Parallel Gripper